M.2 Mounting Screw

Howdy! On M.2 mounts, I normally see a threaded stand-offs so the M.2 board is not bent lower than the mounting plane. The Argon One, M.2 Expansion Board only has the flat circuit board as a mounting surface, so the M.2 would be bent in a downward direction. The mounting screw does have a slot between the screw head and the lower hex surface but it is not thick enough for the M.2 board to sit in between.

What is the correct method of mount the M.2 board so the M.2 board and mount are not stressed?


Me again. Discovered the screw is attached to the standoff. I guess it should have been obvious based on the two different colors.

thanks - phil

1 Like