Step 6 is too late in the installation…
How can you possibly change a jumper when the Pi and daughter board are already installed?
Argon40. Please update your manual.
Step 6 is too late in the installation…
How can you possibly change a jumper when the Pi and daughter board are already installed?
Argon40. Please update your manual.
Yes, I noticed this too - quite annoying. Brings me back to the old days of “read the complete guide before starting”.
It is also difficult to firmware update it, after having assembled it.
And it is not even possible to get the firmware version anywhere.
All three things is irritating.
Btw, in the box, I’ve 2 ribbon flat cables. One is black, the other one is in “copper” color.
The one in “copper” color has a version printed on it which is higher than the version printed on the black one.
Are both cables technically identical? There’s no mention of 2 cables in the doc !!